Subaru IMPREZA 2002 Service Manual page 481

I I
STEERING GEARBOX
POWER ASSISTED SYSTEM (POWER STEERING)
8 ) Put ST3 over pinion, and insert oil seal, then
force-fit oil seal into housing using ST4.
ST1 926370000 INSTALLER A
ST2 34099FA100 STAND BASE
ST3 926360000 INSTALLER A
ST4 927620000 INSTALLER B
I
.
S4M0404A
(1) Oil seal
NOTE:
Apply the specified power steering fluid to the oil
seal and ST3, being careful not to damage oil seal
lip.
Push the oil seal until ST3 contacts housing end
face.
9) Remove ST3, and fit backing washer.
10) Force-fit ball bearing using ST3.
ST1 926370000 INSTALLER A
ST2 34099FA100 STAND BASE
ST3 927640000 INSTALLER B
S4M04051
(1) Ball bearing
(2) Backing washer
NOTE:
Be careful not to tilt ball bearing during installation.
11) Install the snap ring using snap ring pliers.
NOTE:
Rotate the snap ring to check for proper installa-
tion.
12) Apply the specified grease to the dust cover.
I
S4M01566
(1) Dust cover
13) Install the dust cover on the valve assembly.
14) Apply genuine grease to the pinion gear and
bearing of valve assembly.
G4M0150
PS-39