Subaru IMPREZA 2002 Service Manual page 467

10) Install the steering wheel. <Ref. to PS-19, IN-
STALLATION, Steering Wheel.>
Set the steering wheel to neutral and install it onto
steering shaft.
CAUTION:
Insert roll connector guide pin into guide hole
on lower end of surface of steering wheel to
prevent damage. Draw out airbag system con-
nector, horn connector and cruise control con-
nectors from guide hole of steering wheel lower
end.
11) Install the airbag module to the steering wheel.
WARNING:
Always refer to "Air Bag System" before per-
forming the service operation. <Ref. to AB-12,
CAUTION, Driver's Airbag Module.>
E: INSPECTION
1. BASIC INSPECTION
Inspection
Overall length of steering column
Measure overall length of steering column.
Standard overall length of steering column:
TILT STEERING COLUMN
I
POWER ASSISTED SYSTEM (POWER STEERING)
C: DISASSEMBLY
Remove the two screws securing upper steering
column covers, and the two screws securing com-
bination switch, then remove the related parts.
1) Insert the combination switch to the upper col-
umn shaft, and install the upper column cover.
Then route the ignition key harness and combina-
tion switch harness between column cover mount-
D: ASSEMBLY
Corrective action
Replace steering col-
umn assembly.
ing bosses.
Tightening torque:
CAUTION:
Don't overtorque the screw.
1.2 N.m (0.12 kgf-m, 0.9 ft-lb)
Clean the disassembled parts with a cloth, and check d r wear, damage, or any other faults.
pair or replace faulty parts.
necessary, re-
825.7f1.5" (32.51+0.059in)
ST0024
2. AIRBAG MODEL INSPECTION
WARNING:
For airbag model inspection procedures, refer
to "Air Bag System". <Ref. to AB-12, CAUTION,
Driver's Airbag Module.> and <Ref. to AB-12,
INSPECTION, Driver's Airbag Module.>
PS-25