Subaru IMPREZA 2002 Service Manual page 138

FRONT AXLE
DRIVE SHAFT SYSTEM
9) Apply the sufficient grease to oil seal lip.
Specified grease
SHELL 6459N
CAUTION:
If specified grease is not available, remove
bearing grease and apply Auto Rex A instead.
Do not mix different types of grease.
10) Install the disc cover to housing the three bolts.
Tightening torque:
18 N-m (1.8 kgf-m, 13.0 ft-lb)
11) Attach the hub to ST1 securely.
12) Clean the dust or foreign particles from the pol-
ished surface of hub.
13) Using ST2, press the bearing into hub by driv-
ing inner race.
STI 927080000 HUB STAND
ST2 927120000 HUB INSTALLER
CAUTION:
Do not apply pressure more than 25 kN (2.5 ton,
2.3 US ton, 2.5 Imp ton).
G4M0235
E: INSPECTION
1) Inspect the rattle of bearing, give the tires a
shake with grasping both the upper and lower sides
of the tire. And also inspect to rotate the wheel
smoothly.
2) Inspect the lean of axis direction using a dial
gauge. Replace the hub bearing if the load range
exceed the limitation.
Limit:
Maximum: 0.05" (0.0020in)
3) Inspect the removed parts for wear and damage.
If defective, replace with new ones.
CAUTION:
If bearing is faulty, replace it as the bearing
set.
Be sure to replace oil seal at every overhaul.
L
H4M1002C
(A)
Replace as a set.
DS-22