Subaru IMPREZA 2002 Service Manual page 137

FRONT AXLE
I
DRIVE SHAFT SYSTEM
D: ASSEMBLY
1) Attach the hub to ST securely.
ST 927080000 HUB STAND
5) Using pliers, install the snap ring in its groove.
CAUTION:
Make sure to install it firmly to groove.
G4M0230
2) Using a hydraulic press, press the new hub bolts
into place.
CAUTION:
Be sure to press hub bolts until their seating
surfaces contact the hub.
NOTE:
Use 12 mm (0.47 in) dia. holes in HUB STAND to
prevent bolts from tilting.
3) Clean the dust or foreign particles from inside
the housing.
4) Using ST1 and ST2, press a new bearing into
place.
ST1 927400000 HOUSING STAND
ST2 9271 00000 BEARING PULLER
CAUTION:
Always press outer race when installing bear-
ing.
Be careful not to remove the plastic lock from
inner race when installing bearing.
Charge bearing with new grease when outer
race is not removed.
Do not apply pressure more than 30 kN (3.1
ton, 2.8 US ton, 3.1 Imp ton).
Specified grease:
SHELL 6459N
6) Using ST1 and ST2, press the outer oil seal until
it contacts the bottom of housing.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
CAUTION:
Do not apply pressure more than 3.92 kN (0.4
ton, 0.4 US ton, 0.4 Imp ton).
7) Using ST1 and ST2, press the inner oil seal until
it contacts circlip.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
CAUTION:
Do not apply pressure more than 3.92 kN (0.4
ton, 0.4 US ton, 0.4 Imp ton).
G4M0234
8) Invert the ST and housing.
ST 927400000 HOUSING STAND
DS-21