Subaru IMPREZA 2002 Service Manual page 146

REAR AXLE
DRIVE SHAFT SYSTEM
3) Clean the housing interior completely. Using
STI and ST2, press the bearing into the housing.
ST1 927430000 HOUSING STAND
ST2 927440000 BEARING REMOVER
CAUTION:
Always press iouter race when installing
bearing.
Be careful not to remove plastic lock from in-
ner race when installing bearing.
Charge bearing with new grease when outer
race is not removed.
Do not apply pressure more than 30 kN (3.1
ton, 2.8 US ton, 3.1 Imp ton).
S4M0266A
I
4) Using plier, install the snap ring.
CAUTION:
Ensure snap ring fits in groove properly.
5) Using ST1 and ST2, press the outer oil seal unit
it comes in contact with snap ring.
STI 927430000 HOUSING STAND
ST2 927460000 OIL SEAL INSTALLER
CAUTION:
Do not apply pressure more than 3.92 kN (0.4
ton, 0.4 US ton, 0.4 Imp ton).
S4M0267E
(1) Snap ring
6) Invert both ST1 and housing.
7)
Using ST2, press the inner oil seal into the hous-
ing until it touches bottom.
ST1 927430000 HOUSING STAND
ST2 927460000 OIL SEAL INSTALLER
CAUTION:
Do not apply pressure more than 3.92 kN (0.4
ton, 0.4 US ton, 0.4
ImD
ton).
(1) Plier
DS-30