Subaru IMPREZA 2002 Service Manual page 140

REAR AXLE
DRIVE SHAFT SYSTEM
12) Disengage the BJ from the housing splines,
and remove the rear drive shaft assembly.
If it is hard to remove, use STs.
STI 926470000 AXLE SHAFT PULLER
ST2 927140000 AXLE SHAFT PULLER
CAUTION:
Be careful not to damage the oil seal lip when
removing rear drive shaft.
When rear drive shaft is to be replaced, also
PLATE
replace inner oil seal with a new one.
I
N
G4M0247
2. DRUMBRAKE
1) Disconnect the ground cable from battery.
2) Jack-up the vehicle, and remove the rear wheel
cap and wheels.
CAUTION:
Be sure to loosen and retighten the axle nut af-
ter removing wheel from vehicle. Failure to fol-
low this rule may damage wheel bearings.
3) Unlock the axle nut.
4) Remove the axle nut using a socket wrench.
5) Return the parking brake lever and loosen the
adjusting nut.
13) Remove the rear ABS sensor from the back
plate (only vehicle equipped with ABS).
(1) Parking brake lever
(2) Locknut
(3) Adjusting nut
6) Remove the brake drum from hub.
7) If it is difficult to remove brake drum, remove the
adjusting hole cover from the back plate, and then
turn the adjusting screw using a slot-type screw-
driver until the brake shoe separates from the
drum.
(1) ABS sensor
14) Remove the bolts which secure rear housing to
strut, and separate the two.
(1)
Back plate
(2) Wheel cylinder
(3) Adjuster ASSY pawls
(4)
Adjusting lever
(5) Tightening direction
(6) Push
DS-24