Subaru IMPREZA 2002 Service Manual page 469

9
STEERING GEARBOX
POWER ASSISTED SYSTEM (POWER STEERING)
13) Remove the clamp bolts securing gearbox to
the crossmember, and remove the gearbox.
(1) Clamp
B: INSTALLATION
1) Insert the gearbox into the crossmember, being
careful not to damage gearbox boot.
2) Tighten the gearbox to the crossmember bracket
via clamp with bolt to the specified torque.
Tightening torque:
59 N-m (6.0 kgf-m, 43 ff-16)
(1) Clamp
3) Install the four pipes on the gearbox.
(1) Connect the pipes A and B to the four pipe
joints of gearbox. Connect the upper pipe B first,
and lower pipe A.
Tightening torque:
13 N.m (1.3 kgf-m, 9.4 ft-16)
(2) Connect the pipes C and D to the gearbox.
Connect the upper pipe D first, and lower pipe C
second.
15 N.m (1.5 kgf-m, 10.8 ft-16)
Tightening torque:
(1)
Pipe C
(2) Pipe D
4) Install the universal joint. <Ref. to PS-20, IN-
STALLATION, Universal Joint.>
5 ) Connect the tie-rod end and knuckle arm, and
tighten with castle nut. Fit the cotter pin into the nut
and bend the pin to lock.
Castle nut tightening torque:
Tighten to 27.0 N.m (2.75 kgf-m, 19.9 ft-lb),
and tighten further within 60" until cotter pin
hole is aligned with a slot in the nut.
CAUTION:
When connecting, do not hit cap at the bottom
of tie-rod end with hammer.
/,
S4M0379A
(1) Castle nut
(2) Tie-rod end
(3) Knuckle arm
6) Install the front stabilizer to vehicle.
7) Install the front exhaust pipe assembly.
8) Install the sub frame. <Ref. to FS-16, INSTALLA-
TION, Sub Frame.>
PS-27