Parking Brake Lever - Subaru IMPREZA 2002 Service Manual

PARKING BRAKE LEVER
PARKING BRAKE
2. Parking Brake Lever
A: REMOVAL
1) Move the select lever to "P" position or gear shift
lever to 1st gear, then block the wheels.
2) Disconnect the battery ground terminal from bat-
tery.
3) Remove the console box. <Ref. to El-41, RE-
MOVAL, Console Box.>
4) Disconnect the connector of parking brake
switch.
5 ) Loosen the parking cable adjusting nut and con-
sole bracket.
6) Remove the parking brake lever.
7) Remove the inner cable end from equalizer.
S4M0473A
-
8) Unbend the parking brake lever pawls and re-
move cable.
(1) Parking brake lever
(2) Cable
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Parking brake lever;
Adjusting nut;
18 N.m (1.8 kgf-m, 13.0 ft-lb)
6 N-m (0.6 kgf-m, 4.4 ft-lb)
NOTE:
Be sure to pass the cable through the guide in-
side tunnel.
Be sure to adjust the lever stroke. <Ref. to PB-7,
ADJUSTMENT, Parking Brake Lever.>
(1) Equalizer
(2) Inner cable end
PB-6