Subaru IMPREZA 2002 Service Manual page 364

I
DIAGNOSTICS CHART WITH SUBARU SELECT MONITOR
ABS (DIAGNOSTICS)
Step
9 CHECK G SENSOR.
Measure the voltage between G sensor con-
nector terminals.
Connector 8 i terminal
(8292)
NO.
2 (+)
-
NO.
3 ( - ) :
10 CHECK ABSCM&W.
1)Turn the ignition switch to OFF.
2)Connect all connectors.
3)Erase the memory.
4)Perform the inspection mode.
5)Read out the diagnostic trouble code.
CHECK ANY OTHER DIAGNOSTIC TROU-
BLE CODES APPEARANCE.
11
Check Yes
Is the voltage between 0.5 and Go to step 10.
0.9 V when G sensor is
inclined backwards to 90°?
Is the same diagnostic trouble Replace the
code as in the current diagno- ABSCM&H/U.
sis still being output? <Ref. to ABS-7,
ABS Control Mod-
ule and Hydraulic
Control Unit
(ABSCM&H/U).>
Are other diagnostic trouble Proceed with the
codes being output? diagnosis corre-
sponding to the
diagnostic trouble
code.
ABS-1 70
No
Replace the G
sensor. <Ref. to
ABS-23, G Sen-
sor.>
Go to step 11.
A
temporary poor
contact.