Subaru IMPREZA 2002 Service Manual page 368

DIAGNOSTICS CHART WITH SUBARU SELECT MONITOR
ABS (DIAGNOSTICS)
Step
10 CHECK G SENSOR.
Measure the voltage between G sensor con-
nector terminals.
Connector & terminal
(8292) NO. 2 (+)
-
NO. 3 ( - ) :
11 CHECK G SENSOR.
Measure the voltage between G sensor con-
nector terminals.
Connector & terminal
(8292) NO. 2 (+)
-
NO.
3
( - ) :
12 CHECK ABSCM&W.
1)Turn the ignition switch to OFF.
2)Connect all connectors.
3)Erase the memory.
4)Perform the inspection mode.
5)Read out the diagnostic trouble code.
CHECK ANY OTHER DIAGNOSTIC TROU-
BLE CODES APPEARANCE.
13
Check Yes
Is the voltage between 3.7 and Go to step 11.
4.1
V
when G sensor is
inclined forwards to 90°?
Is the voltage between 0.5 and Go to step 12.
0.9 V when G sensor is
inclined backwards to 90°?
Is the same diagnostic trouble Replace the
code as in the current diagno- ABSCM&H/U.
sis still being output? <Ref. to ABS-7,
ABS Control Mod-
ule and Hydraulic
Control Unit
(ABSCM&H/U).>
Are other diagnostic trouble Proceed with the
codes being output? diagnosis corre-
sponding to the
diagnostic trouble
code.
sensor. <Ref. to
ABS-23, G Sen-
I
sor.>
sensor. <Ref. to
ABS-23, G Sen-
sor.>
Go to step 13.
A temporary poor
contact.
ABS-I 82