Subaru IMPREZA 2002 Service Manual page 472

I
STEERING GEARBOX
POWER ASSISTED SYSTEM (POWER STEERING)
a
13) Carefully draw out the input shaft and remove
the valve assembly.
14) Using a sharp pointed pliers, rotate the rack
stopper in the direction of the arrow until the end of
the circlip comes out of the stopper. Rotate the cir-
clip in the opposite direction and pull it out.
(1 ) Rack stopper
15) Pull the rack assembly from the cylinder side,
and draw out the rack bushing and rack stopper to-
gether with the rack assembly.
CAUTION:
Be careful not to contact rack to inner wall of
cylinder when drawing out. Any scratch on cyl-
inder inner wall will cause oil leakage.
S4M0402A
( 3 )
16) Remove the rack bushing and rack stopper
from the rack assembly.
CAUTION:
Do not reuse removed rack bushing and circlip.
17) Remove the oil seal from rack.
18) Insert ST from the pinion housing side and re-
move the oil seal using a press.
ST 34099FA110 INSTALLER
L A
S4M01638
(1) Press
(2) Oil seal
NOTE:
Discard the removed the oil seal.
(1) Rack bushing
(2) RackASSY
(3) Rack stopper
PS-30