Brake Pedal - Subaru IMPREZA 2002 Service Manual

BRAKE PEDAL
1
BRAKE
18.Brake Pedal
A: REMOVAL
1.
MT MODEL
B: INSTALLATION
1 ) Install in the reverse order of removal.
CAUTION:
If the cable clamp is damaged, replace it with
a new one.
Never fail to cover the outer cable end with
boot.
.
Be careful not to kink the accelerator cable.
Always use new clevis pins.
2) Adjust the clutch pedal <Ref. to CL-27, ADJUST-
1) Remove the steering bolts.
2) Raise the vehicle on hoist and remove the two
bolts which secure steering unit to underside of
body.
3) Lower the vehicle to floor.
4) Remove the instrument panel lower cover from
instrument panel. MENT, Clutch Pedal.>
et. INSPECTION, Brake Pedal.>
5) Disconnect the following parts from pedal bra&-
3) Inspect after pedal installation <Ref. to BR-53,
Operating rod of brake booster
Electrical connectors (for stop light switch, etc.)
6) Remove the clevis pin which secures lever to
push rod.
7) Remove the nut which secures clutch master
cylinder.
8) Remove the steering assembly.
9) Remove the accelerator pedal.
10) Remove the bolts and nuts which secure pedal
bracket.
2.
ATMODEL
1 ) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover from
instrument panel.
3) Remove the clevis pin which secures brake ped-
al to brake booster operating rod. Also disconnect
the stop light switch connector.
4) Remove the two bolts and four nuts which se-
cure brake pedal to pedal.
BR-51