Subaru IMPREZA 2002 Service Manual page 180

REAR ABS SENSOR
ABS
5. Rear ABS Sensor
B: INSTALLATION
A: REMOVAL
plate.
1) Disconnect the ground terminal from battery.
and remove the wheel.
3) Remove the rear seat and disconnect the rear
ABS sensor connector.
1) Temporarily install the rear ABS sensor on back
CAUTION:
piece and tone wheel's teeth against adjacent
metal parts during installation.
2)
Jack-up the vehicle, suppofl it with rigid racks,
Be careful not to strike the ABS sensor's pole
4) Remove the rear sensor harness bracket from
rear trailing link and bracket.
5) Remove the rear ABS sensor from back plate.
(1 ) Rear ABS sensor
(1 ) Rear ABS sensor
link.
Tightening torque:
32 N-m (3.3 kgf-m, 24 ff-lb)
(1 ) Rear sensor harness
(2) Trailing link
ABS-I 8