Appendix Eietf Radius Attributes Support - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Appendix E
Remote Authentication Dial-In User Service (RADIUS) attributes carry specific authentication,
authorization, information and configuration details for the request and reply. This appendix lists
the RADIUS attributes currently supported by the switch.
RADIUS attributes are supported by the IETF standard and Vendor-Specific Attribute (VSA). VSA
allows the vendor to create an additionally owned RADIUS attribute. For more information about
D-Link VSA, refer to Appendix E RADIUS Attributes Assignment.
IETF standard RADIUS attributes are defined in the RFC 2865 Remote Authentication Dial-In User
Service (RADIUS), RFC 2866 RADIUS Accounting, RFC 2868 RADIUS Attributes for Tunnel
Protocol Support, and RFC 2869 RADIUS Extensions.
The following table lists the IETF RADIUS attributes supported by the D-Link switch.
1. RADIUS Authentication Attributes
Number
1
2
3
4
5
6
7
8
12
18
24
26
27
29
30
31
32
60
61
64
IETF RADIUS
Attributes Support
IETF Attribute
User-Name
User-Password
CHAP-Password
NAS-IP-Address
NAS-Port
Service-Type
Framed-Protocol
Framed-IP-Address
Framed-MTU
Reply-Message
State
Vendor-Specific
Session-Timeout
Termination-Action
Called-Station-ID
Calling-Station-ID
NAS-Identifier
CHAP-Challenge
NAS-Port-Type
Tunnel-Type
1327