Error Message - MIMAKI TS100-1600 Operation Manual

Chapter 5 Troubleshooting
Message
Wrong Ink IC
Replace Ink

Error Message

Error Message
number
04 PARAM ROM
108 HD THERMIS [1234]
108 HD CONNECT [1234]
122 CHECK:SDRAM
128 HDC FIFO OVER
128 HDC FIFO UNDER
129 Battery Exchange
12a HDC SPEED
130 HD DATA SEQ
148 E-LOG SEQ
151 Main PCB V1R2
152 Main PCB V2R5
153 Main PCB V3R3
154 Main PCB V05
157 Main PCB VTT
158 Main PCB V36-2
15f HEAD DRIVE HOT
16e Main PCB V3R3B
Cause
• An error occurred with the
information on the ink IC
chip.
• The ink IC chip was
registered when an ink
end or ink near-end error
occurred.
Cause
• A problem was detected
with the main PCB.
• A problem was detected
with print head
temperature control.
• A problem was detected
with the print head
connection.
• A problem was detected
with the SDRAM.
• A problem was detected
with the print head control
PCB.
• The internal clock battery
is spent and must be
replaced.
• A problem was detected
with the print head control.
• A log control abnormality
was detected.
• A problem was detected
with the main PCB power
supply circuit.
• The COM drive has
overheated.
• A problem was detected
with the main PCB power
supply circuit.
128
Corrective action
1. Check to confirm the ink IC chip was
inserted correctly. "Registering the Ink
IC Chip"(P. 42)
2. Turn off the main power and wait a while
before turning back on.
3. Replace with new ink.
Displayed"(P. 37)
• Mount new ink and register the ink IC
chip.
Corrective action
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
• Contact your local distributor, our
sales office, or service center.
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
"When Ink End is