Error Message - MIMAKI JV3-75 SP II Operation Manual

Error message

ERROR 23
HOST I / F
ERROR 24
I / F INITIAL
ERROR 30
OPERATION
ERROR 34
DATA REMAIN
ERROR 40
MOTOR X
ERROR 41
MOTOR Y
ERROR 42
X CURRENT
ERROR 43
Y CURRENT
ERROR 46
WIPER
ERROR 50
MEDIA SENSE
ERROR 51
Y ORIGIN
ERROR 57
HEAD HIGHT SENS.
Cause
HOST I/F Timeout error has
arisen during communication
between the host computer and
interface board.
Initial operation failure of the I/F
board and control board.
An error occurs on the interface
between the I/F board and the
control board.
Settings for functions have been
tried to be changed though there
remains received data that has not
yet been printed.
The Xmotor has been overload.
The Ymotor has been overload.
Overcurrent error on the Xmotor
has been detected.
Overcurrent error on the Ymotor
has been detected.
The wiper position is not
correct.
Paper could not be detected.
The media set position or media
itself is not correct.
Origin could not be detected.
Head height could not be
detected.
- 6.9 -
Corrective measure
Check to be sure that the cable is
securely connected to the host
computer and interface board.
Also, check to ascertain that no
error has arisen on the host
computer side.
Turn off the power to the device
and turn it on after a while. If the
same error message appears again
on the LCD, contact your local
distributor to call for service.
Perform a proper operation.
Print all pieces of received data or
execute the data clear function.
Then, change the settings.
Turn off the power to the device
and turn it on after a while. If the
same error message appears again
on the LCD, contact your local
distributor to call for service.
Refer to "Setting the media".
page 2.16.
If this error cannot be resolved
even after setting it correctly,
contact the dealer.
Turn off the power to the device
and turn it on after a while. If the
same error message appears again
on the LCD, contact your local
distributor to call for service.