Table 203: Ip Routing Commands; Table 204: Global Routing Configuration Commands - Edge-Core ECS4120-28F Reference Manual

30
Global Routing Configuration
IP Routing Commands
After network interfaces are configured for the switch, the paths used to send
traffic between different interfaces must be set. If routing is enabled on the switch,
traffic will automatically be forwarded between all of the local subnetworks.
However, to forward traffic to devices on other subnetworks, either configure fixed
paths with static routing commands, or enable a dynamic routing protocol that
exchanges information with other routers on the network to automatically
determine the best path to any subnetwork.
This section includes commands for static routing. These commands are used to
connect between different local subnetworks or to connect the router to the
enterprise network.

Table 203: IP Routing Commands

Command Group
Global Routing Configuration
.

Table 204: Global Routing Configuration Commands

Command
IPv4 Commands
ip route
show ip route
show ip route database
show ip route summary
Function
Configures global parameters for static routing, displays the routing
table and statistics for protocols used to exchange routing
information
Function
Configures static routes
Displays specified entries in the routing table
Displays static entries in the routing table
Displays summary information for the routing table
– 897 –
Mode
GC
PE
PE
PE