Table of Contents
Advertisement
Available commands are listed below.
N
Display the next page.
Press "N" to change the display to the next page.
P
Display the previous page.
Press "P" to change the display to the previous page.
C
Create new VLAN.
Pressing "C" opens the "VLAN Create Menu" screen. For details, refer to the next section
(4.7.1.c).
D
Delete a VLAN that has been configured.
Press "D." The command prompt changes to "Enter VLAN ID>." Enter VLAN ID to delete
with a value of 2 to 4094.
M Set the management VLAN.
Press "R." The command prompt changes to "Enter index number>." Enter VLAN ID to
change the setting as a management VLAN with a value of 1 to 4094.
I
Configure Internet Mansion mode.
Press "I." The command prompt changes to "Enable or Disable Internet Mansion Function?
(E/D>." Enter "E" to enable or "D" to disable the Internet Mansion mode, respectively. If you
press "E", the command prompt changes to "Uplink port?>." Enter a port number to change
the setting as Uplink port. By this setting, you can set the device to be optimum
environment as a Switching Hub used in Internet Mansion. By this setting, the specified
port becomes an Uplink port, and other ports become possible to communicate only with
downlink port. Downlink ports become impossible to communicate each other. So, it
becomes possible to ensure security between each resident.
(There are some constrained conditions for use. Please execute configuration after
confirming the precautions shown in the next page.)
O
Configure a port structure in VLAN.
Press "O." The command prompt changes to "Enter VLAN ID>." Enter VLAN ID to
change the setting with a value of 1 to 4094. Then, the screen changes to "VLAN
modification Menu" screen. For details, refer to the section (4.7.1.d).
S
Configure and confirm PVID by port.
Pressing "S" opens the "VLAN Port Configuration Menu" screen. For details, refer to the
section (4.7.1.e).
Q
Return to the previous menu.
Note:
When creating a new VLAN, PVID settings are also required.
After create VLAN on this screen, make sure to confirm the
configuration of Fig. 4-7-5 and Fig. 4-7-6.
You cannot delete VLAN which VLAN ID is still remained as PVID
settings. Delete VLAN after changing PVID to other VLAN ID.
90
Advertisement
Table of Contents
