Table of Contents
Advertisement
Available commands are listed below.
E
Set Edge Status of each port.
Press "E" to change the command prompt to "Select port number to be changed>."
Enter a port number. Then, "Set edge port for port # (T/F)>" is displayed. For True,
press "T." For False, press "F."
T
Set P-to-P Status of each port.
Press "T" to change the command prompt to "Select port number to be changed>."
Enter a port number. Then, "Set point-to-point port for port # (A/T/F)>" is displayed. For
Auto, press "A." For True, press "T." For False, press "F."
M Restart the operation of the spanning tree.
Press "M" to change the command prompt to "Select port number to be changed>."
Enter a port number. Then, "Restart the protocol migration process for port #? (Y/N)>"
is displayed. If you restart, press "Y." If not, press "N."
Q
Return to the previous menu.
116
Advertisement
Table of Contents
