Table of Contents
Advertisement
Available commands are listed below.
E
Configure the global Spanning Tree status
Press "E." The command prompt changes to "Enable or Disable STP (E/D)>." Enter "E" to
enable the Spanning Tree function, or "D" to disable, respectively.
V
Configure an operation mode of Spanning Tree Protocol.
Press "V." The command prompt changes to "Set RSTP protocol version (S/R)>." Enter
"S" to operate with IEEE802.1D-compatible Spanning Tree Protocol, or "R" to operate
with IEEE802.1w Rapid Spanning Tree Protocol, respectively.
B
Configure basic setting by port.
Press "B" to open the "Basic Port Configuration" screen and configure basic setting by
port. For configuration method, refer to the section (4.7.3.a).
A
Configure advanced setting by port.
Press "A" to open the "Advanced Port Configuration" screen and configure advanced
setting by port. For configuration method, refer to the section (4.7.3.b).
P
Configure bridge priority.
Press "P." The command prompt changes to "Enter bridge priority>." Enter a value
within the range specified in the black band at the bottom of the screen.
H
Configure Bridge hello time.
Press "H." The command prompt changes to "Enter bridge hello time>." Enter a value
within the range specified in the black band at the bottom of the screen.
M Configure Bridge maximum age.
Press "M." The command prompt changes to "Enter bridge maximum age>." Enter a
value within the range specified in the black band at the bottom of the screen.
F
Configure Bridge forward delay.
Press "F." The command prompt changes to "Enter bridge forward delay>." Enter a
value within the range specified in the black band at the bottom of the screen.
I
Display topology information by port.
Press "I" to open the "Designated Topology Information" screen and refer topology
information by port. For details, refer to the section (4.7.3.c).
Q
Return to the previous menu.
Note: All values of "Bridge Hello Time", "Bridge Maximum Age", and "Bridge
Forward Delay" are related to each other. If you change one parameter,
it automatically affects the setting range for other parameters. The
setting range will be displayed in the black band at the bottom of the
screen.
111
Advertisement
Table of Contents
