Table of Contents
Advertisement
Available commands are listed below.
T
Set the waiting time after receiving a Leave packet.
Press "T." The command prompt changes to "Set leave delay time>." Set the time to
wait after receiving a Leave packet in seconds between 1 and 10.
S
Set the operation after receiving a Leave packet.
Press "S." The command prompt changes to "Select port number to be changed>."
Enter the port number to change the setting. Then, the command prompt changes to
"Set leave mode (N/I)>." Press "I" to send a Leave packet to the router port immediately
after receiving it. Press "N" to wait for the specified Leave Delay Time before sending it
to the router port.
Q
Return to the previous menu.
134
Advertisement
Table of Contents
