Designated Topology Information - Panasonic Switch-M8ePWR PN27089KA Operation Manual

4.7.4.c. Designated Topology Information
On the Rapid Spanning Tree Configuration Menu, pressing "I" opens the
Designated Topology Information screen, as shown in Fig. 4-7-17. This screen
displays configuration information of the spanning tree for each port.
PN27089K/PN27089KA Local Management System
Rapid Spanning Tree Configuration -> Designated Topology Information
Port Trunk Link
---- ----- ---- ----------------- ----------- ----------------- -----------
1 --- Down 0000 000000000000
2 --- Down 0000 000000000000
3 --- Down 0000 000000000000
4 --- Down 0000 000000000000
5 --- Down 0000 000000000000
6 --- Down 0000 000000000000
7 --- Down 0000 000000000000
8 --- Down 0000 000000000000
9 --- Down 0000 000000000000
10 --- Down 0000 000000000000
-------------------------------- <COMMAND> -----------------------------------
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Fig. 4-7-17 Designated Topology Information
Screen Description
Port
Link
Desig.Root
Desig.Cost
Desig.Bridge
Desig.Port
Available commands are listed below.
Q Return to the previous menu.
Desig. Root Desig. Cost
0
0
0
0
0
0
0
0
0
0
Displays the port number.
Displays the state of link.
UP Link is established normally.
DOWN Link is not established.
Displays root bridge ID.
Displays cost under transmission.
Displays bridge ID of a designated bridge.
Displays port ID of a designated port. (Port ID is a combination of
port priority value and port number.)
117
Desig. Bridge Desig. Port
0000 000000000000 00 00
0000 000000000000 00 00
0000 000000000000 00 00
0000 000000000000 00 00
0000 000000000000 00 00
0000 000000000000 00 00
0000 000000000000 00 00
0000 000000000000 00 00
0000 000000000000 00 00
0000 000000000000 00 00