Panasonic Switch-M8ePWR PN27089KA Operation Manual page 60

Available commands are listed below.
C Configure the idle timeout settings for automatically terminating a console-connected
session if no input is made.
Press "C." The command prompt changes to "Enter console idle timeout>." Enter a
value from 0 to 60 (minutes). Entering "0" disables the automatic termination.
T Configure the idle timeout settings for automatically terminating a Telnet-connected
session if no input is made.
Press "T." The command prompt changes to "Enter telnet idle timeout>." Enter a value
from 1 to 60 (minutes).
N Edit the login username.
Press "N." The command prompt changes to "Enter current password>." Enter the
current password. After entering the correct password, the command prompt changes
to "Enter new name>." Enter a new username in 12 characters.
P Edit the login password.
Press "P." The command prompt changes to "Enter old password>." Enter the current
password. After entering the correct password, the command prompt changes to
"Enter new password>." Enter a new password in 12 characters. After entering the
password, the command prompt changes to "Retype new password>" for
confirmation. Enter the new password again.
L Configure the Telnet access settings.
Press "L." The command prompt changes to "Enable or Disable telnet server(E/D)>."
Enter "E" to enable the access. Enter "D" to disable the access.
S Configure the SNMP access settings.
Press "S." The command prompt changes to "Enable or Disable SNMP Agent(E/D)>."
Enter "E" to enable the access. Enter "D" to disable the access.
A Configure a terminal accessible via Telnet.
Press "A" to move to the Telnet Access Limitation Menu. For configuration details, refer
to the next section (4.6.6.a).
Y Configure the settings for sending system logs to the Syslog server.
Press "Y." The command prompt changes to "Enable or Disable Syslog Transmission
(E/D)>."
Enter "E" to enable the Syslog transmission to the Syslog server. Enter "D" to disable the
Syslog transmission to the Syslog server.
R Configure the access settings to access the RADIUS server. The RADIUS is used in the
IEEE802.1X port-based authentication.
Press "R" to move to the RADIUS Configuration page. For configuration details, refer to
the next section (4.6.7.b).
G Configure the settings for sending system logs to the Syslog server.
Press "G" to move to the Syslog Transmission Configuration page. For configuration
details, refer to the next section (4.6.7.c).
I Configure the access settings for the IP address configuration software, bundled with the
Panasonic network cameras.
Press "I." The command prompt changes to "Enable or Disable IP setup interface
(E/D)>."
Enter "E" to enable the access. Enter "D" to disable the access.
60