Table of Contents
Advertisement
Screen Description
System up for:
Displays the cumulative time since the power on of this Switching Hub.
Boot / Runtime
Displays this Switching Hub's firmware version.
Code Version:
The left side displays the Boot Code and the right side displays the Runtime
Code.
("TFTP Software Upgrade" in 4.9.1 is about Runtime Code update.)
Hardware
Displays the hardware information.
Information
Version:
CPU Utilization:
DRAM / Flash
Size:
DRAM User
Area Size:
System Fan
Status:
System
Temperature:
Administration
Items shown here are configured in accordance with "4.6.1 System
Information
Administration Configuration."
Switch Name:
Switch
Location:
Switch
Contact:
System
Items shown here are configured in accordance with "4.6.2 System IP
Address
Configuration."
Information
MAC address:
IP Address:
Subnet Mask:
Default
Gateway:
DHCP Mode:
Displays the hardware version information.
Displays the CPU utilization.
Displays the sizes of installed DRAM and FLASH memory.
Displays the sizes of the user area memory and unused
memory.
Displays the operation status of installed fan.
Displays Good when the fan is operating normally and Fail
when it fails or stops.
Displays the internal temperatures of the Switching Hub.
The sensors measure the temperature of CPU and system.
Displays the Switching Hub name. The factory default
setting is blank.
Displays the Switching Hub's location. The factory default
setting is blank. For configuration details, refer to 4.6.1.
Displays the contact information. The factory default
setting is blank. For configuration details, refer to 4.6.1.
Displays the MAC address of this Switching Hub. This value
is uniquely assigned to each device and cannot be
changed.
Displays the Switching Hub's current IP address. 0.0.0.0 is
the factory default setting. For configuration details, refer
to 4.6.2.
Displays the Switching Hub's current subnet mask. 0.0.0.0
is the factory default setting. For configuration details,
refer to 4.6.2.
Displays the IP address of the router for the default
gateway. 0.0.0.0 is the factory default setting. For
configuration details, refer to 4.6.2.
Displays whether to get an IP address using DHCP. For
configuration details, refer to 4.6.2.
38
Advertisement
Table of Contents
