Table of Contents
Advertisement
Note:
If each Switching Hub uses LACP passive mode, LACP negotiation is not
executed then the packet storm may be occurred. When constructing
trunking using LACP, make sure to configure one side to be Active.
Available commands are listed below.
N
Display the next page.
Press "N" to change the display to the next page.
P
Display the previous page.
Press "P" to change the display to the previous page.
T
Set System Priority value of this Switching Hub in LACP.
Press "T." The command prompt changes to "Enter system priority for LACP >."
A
Configure new trunking settings.
Press "A." The command prompt changes to "Enter trunk group admin key>." Enter a
group number to change the setting. The command prompt changes to "Enter port
member for group key #>." Enter a port number you wish to do trunking. When
entering multiple port numbers, delimit with comma (,) with no space (example:
"1,2,3"), or hyphenate the continuous numbers (example: "1-8"). Then, the command
prompt changes to "LACP Active, LACP Passive or Manual trunk setting(A/P/M)>."
Enter "A" to make operation mode Active, or "P" to make it Passive, or "M" to make it
Manual, respectively.
R
Remove trunking settings.
Press "R." The command prompt changes to "Enter trunk group admin key>." Enter a
group number you wish to delete. The command prompt changes to "Enter port
member port for group key #>." Enter a port number you wish to do rdelete. When
entering multiple port numbers, delimit with comma with no space, or hyphenate the
continuous numbers.
M Modify the operation mode of trunking.
Press "M." The command prompt changes to "Enter trunk group admin key>." Enter a
group number you wish to modify. Then, the command prompt changes to "LACP
Active, LACP Passive or Manual trunk setting(A/P/M)>." Enter "A" to make operation
mode Active, or "P" to make it Passive, or "M" to make it Manual, respectively.
O
Set System Priority value of this Switching Hub by port in trunking.
Press "o" to open the "Set port Priority" screen. For detailed setting procedure, refer to
the section (4.7.2.c).
G
Display a status of LACP group.
Press "G." The command prompt changes to "Enter trunk group number >." Enter a key
of group you wish to display. (Only the group of which mode is Active or Passive can be
entered.) Then, the screen changes to "LACP Status." For details, refer to the section
(4.7.2.d).
Q
Return to the previous menu.
100
Advertisement
Table of Contents
