Table of Contents
Advertisement
Available commands are listed below.
S
Set a status of Syslog Transmission.
Press "S." The command prompt changes to "Enter manager entry number>." Enter No.
to change the setting. Then, the command prompt changes to "Enable or Disable Server
(E/D)>." Enter "E" to enable, or "D" to disable the server.
F
Set Facility.
Press "F." The command prompt changes to "Enter manager entry number>." Enter No.
to change the setting. Then, the command prompt changes to "Enter Server Facility>."
Enter a value of 0 to 7 (Local0 to Local7).
I
Set an IP address of Syslog server.
Press "I." The command prompt changes to "Enter manager entry number>." Enter No.
to change the setting. Then, the command prompt changes to "Enter IP address for
manager>." Enter an IP address of Syslog server.
Y
Set information that is added to a system log to be transmitted.
Press "Y." The command prompt changes to "Enter manager entry number>." Enter No.
to change the setting. Then, the command prompt changes to "Enter Include
Information>." Enter "S" when adding a SysName of this Switching Hub, or "I" when
adding IP address, or "N" when not adding IP address.
C
Delete setting information of Syslog Transmission.
Press "C." The command prompt changes to "Enter manager entry number>." Enter No.
to delete. Then, the command prompt changes to "Clear Syslog Server information>."
Enter "Y" when deleting, or "N" when not deleting the sever information.
Q
Return to the previous menu.
67
Advertisement
Table of Contents
