Table of Contents
Advertisement
Available commands are listed below.
A
Enable/disable a port.
Press "A." The command prompt changes to "Select port number to be changed>."
Enter a port number to change the setting. To configure all ports at once, enter "0" as
the port number. Then, the command prompt changes to "Enable or Disable port #
(E/D)>." Press "E" to enable the port. Press "D" to disable it. As the change is applied,
the display on the upper screen is updated automatically.
M Configure the speed and full-duplex/half-duplex settings for each port.
Press "M." The command prompt changes to "Enter port number>." Enter a port
number to change the setting. To configure all ports at once, enter "0" as the port
number. Then, the command prompt changes to "Enter mode for port # (A/N)>." Press
"A" to enable the auto negotiation mode. Press "N" to disable it. If "N" is selected, the
command prompt changes to "Enter speed for port #(10/100)>." Select a desired
communication speed. Upon setting, the command prompt changes to "Enter duplex
for port #(F/H)>." Select "F" for full-duplex, or "H" for half-duplex. As the change is
applied, the display on the upper screen is updated automatically.
Mode:
A:
N:
Speed:
10:
100:
Duplex:
F:
H:
F
Enable/disable the flow control.
Press "F." The command prompt changes to "Select port number to be changed>."
Enter a port number you to change the setting. To configure all ports at once, enter "0"
as the port number. Then, the command prompt changes to "Enable or Disable flow
control for port # (E/D)>." Press "E" to enable the function. Press "D" to disable it. As
the change is applied, the display on the upper screen is updated automatically.
S
Enable/disable the AUTO-MDI function.
Press "S." The command prompt changes to "Enter port number>." Enter a port number
to change the setting. To configure all ports at once, enter "0" as the port number.
Then, the command prompt changes to "Enable or Disable Auto-MDl for port #
(E/D)>." Press "E" to enable the function. Press "D" to disable it. As the change is
applied, the display on the upper screen is updated automatically.
Q
Return to the previous menu.
Note:
The screen displays the port status; however, the status is not
automatically updated. To display the latest status, press any key.
Enable the auto negotiation mode.
Disable the auto negotiation mode.
(fixing the speed at 1000BASE-T is not supported)
Set at 10 Mbps.
Set at 100 Mbps.
Set at full-duplex.
Set at half-duplex
53
Advertisement
Table of Contents
