Panasonic Switch-M8ePWR PN27089KA Operation Manual page 57

Screen Description
Port Displays the port number.
Link Displays the current link status.
Up
Down
Trunk Displays the group number for a trunked port.
Type Displays the port type.
100TX
1000T
1000X
Mode Displays the communication speed and full-duplex/half-duplex settings.
For all ports, 'Auto' is the factory default setting.
Auto
100-FDx(100F)
100-HDx(100H)
10-FDx(10F)
10-HDx(10H)
Power- Displays the status of the MNO series power saving mode.
saving For all ports, 'Half' is the factory default setting.
Half
Full
Disabled
Available commands are listed below.
P Configure the MNO series power saving mode.
Press "P." The command prompt changes to "Select port number to be changed>."
Enter a port number to change the setting. To configure all ports at once, enter "0" as
the port number. Then, the command prompt changes to "Enter Power Saving mode
for port (F/H/D)>." Press "F" to enable the mode. Press "D" to disable it. Press "H" to
select the MNO series power saving mode that prioritizes connection with other
devices. As the change is applied, the display on the upper screen is updated
automatically.
Q Return to the previous menu.
A link has been established successfully.
A link has not been established.
The port type is 10/100BASE-TX.
The port type is 10/100/1000BASE-T.
The port type is SFP extension port.
Auto negotiation mode
100 Mbps full-duplex
100 Mbps half-duplex
10 Mbps full-duplex
10 Mbps half-duplex
The MNO series power saving mode status is enabled (Half).
The MNO series power saving mode status is enabled (Full).
The MNO series power saving mode status is disabled.
57