Table of Contents
Advertisement
4.7.2.d. LACP Group Status
On the Trunk Configuration Menu, pressing "G" command and specifying Key
that has become LACP group open the LACP Group Status screen, as shown in
Fig. 4-7-10. In this screen, you can confirm the status of LACP group. (Displaying
status is possible only for key of which mode is Active or Passive.)
PN27089K/PN27089KA Local Management System
Trunk Configuration Menu -> LACP Status
System Priority :
System ID
Key
Aggregator
---------- --------------------------------
-------------------------------- <COMMAND> -----------------------------------
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
System Priority:
System priority is an order of priority in this Switching Hub required for
constructing trunking on the network using LACP. Smaller number has
higher priority. The factory default setting is 1.
System ID:
System ID is an identifier of this Switching Hub required for constructing
trunking on the network using LACP.
MAC Address of this Switching Hub becomes this System ID, and it is not
possible to change this ID. Combination of System Priority value and System
ID becomes a System ID in LACP.
Key:
Indicates the group number of trunking.
Aggregator
Aggregator is a number of logical interface of trunking. This is the same
number as the one of the port of which Priority value is the highest in the
ports that are constructing trunking.
Attached Port
This is a number of physical interface (Port) connected to logical interface
List
(Aggregator).
1
:
xx:xx:xx:xx:xx:xx
:
1
Attached Port List
Fig. 4-7-10 LACP Group Status
104
Advertisement
Table of Contents
