Table of Contents
Advertisement
Available commands are listed below.
S
Enable/disable the trap receiver.
Press "S." The command prompt changes to "Enter manager entry number>." Enter an
entry number for the trap receiver to change the setting. Then, the command prompt
changes to "Enable or Disable Trap Receiver (E/D)>." Press "E" to enable the TRAP
receiver. Press "D" to disable it.
I
Set an IP address for the trap receiver.
Press "I." The command prompt changes to "Enter manager entry number>." Enter an
entry number for the trap receiver to change the setting. Then, the command prompt
changes to "Enter IP address for trap receiver>." Enter the IP address.
D
Set trap conditions.
Press "D." The screen changes to the Enable/Disable Individual Trap Menu.
For detailed configuration, refer to the next section (4.6.3.c).
C
Set a community name for a trap receiver.
Press "C." The command prompt changes to "Enter manager entry number>." Enter an
entry number for a trap receiver to change the setting. Then, the command prompt
changes to "Enter community name for trap receiver>." Enter a community name.
Q
Return to the previous menu.
47
Advertisement
Table of Contents
