Table of Contents
Advertisement
Available commands are listed below.
P
Set an IP address of SNTP server.
Press "P." The command prompt changes to "Enter new IP address>." Enter an IP
address of SNTP server.
I
Set an interval time for SNTP synchronization.
Press "I." The command prompt changes to "Enter Interval Time>." Enter an interval of
time synchronization with SNTP server with a value of 1 to 1440 (minutes).
The factory default setting is 1440 minutes (1 day).
E
Set the application of Daylight Saving (Summer time).
Press "E." The command prompt changes to "Enable or Disable Daylight Saving (E/D)>."
Enter "E" to apply, or "D" not to apply Daylight Saving.
But, in case time zone is set to where daylight saving is not applied, this configuration
is not available.
When this Switching Hub is used domestically, this configuration is not required.
Z
Set time zone.
Press "Z" to open a list of time zones. Specify a time zone to set.
The factory default setting is "(GMT+09:00) Osaka, Sapporo, Tokyo."
Q
Return to the previous menu.
Note:
In case SNTP server is located outside of firewall, connection with SNTP
server may not be possible depending on settings by system
administrator.
For details, ask to your system administrator.
To disable SNTP synchronization function, set SNTP server IP to 0.0.0.0.
82
Advertisement
Table of Contents
