Table of Contents
Advertisement
Available commands are listed below.
E
Configure the status of the loop detection function.
Press "E." The command prompt changes to "Enable or Disable Loop Detection (E/D)>."
Press "E" to enable the function. Press "D" to disable it.
I
Press "I." The Loop History screen opens.
L
Configure the status of the loop detection function for each port.
Press "L."The command prompt changes to "Select port number to be changed>." Enter
a port number you to change the setting. The command prompt changes to "Enable or
Disable Loop Detection (E/D)>." Press "E" to enable the function. Press "D" to disable it.
When entering multiple port numbers, delimit with comma, or hyphenate the
continuous numbers. To configure all ports, enter "0" as the port number.
S
Configure the status of the Recovery mode that can automatically recover a blocked port.
Press "S." The command prompt changes to "Select port number to be changed>."Enter
the port number to change the setting. Then, the command prompt changes to
"Enable or Disable Recovery for port x (E/D)>." Press "E" to enable the automatic port
recovery. Press "D" to disable it.
When entering multiple port numbers, delimit with comma, or hyphenate the
continuous numbers. To configure all ports, enter "0" as the port number.
T
Displays the Recovery Time (seconds) which is a waiting time until a port starts to be
automatically recovered after being blocked.
Press "T." The command prompt changes to "Select port number to be changed>."
Enter the port number to change the setting. Then, the command prompt changes to
"Enter Recovery Timer >." Enter a value between 60 and 600 (seconds) as the recovery
time.
Q
Return to the previous menu.
Note:
When you change the Global Loop Detection status, all configuration
will be saved into the flash automatically.
156
Advertisement
Table of Contents
