Table of Contents
Advertisement
Available commands are listed below.
S
Switch enabled/disabled of the QoS function.
Press"S" to change the command prompt to "Enable or Disable QoS (E/D)>."
To enable the QoS function, press "E." To disable it, press "D."
M Assign priority (Traffic Class) to a priority value of IEEE802.1p.
Press "M" to change the command prompt to "Enter Priority (E/D)>." Enter a priority
value (0 to 7) to be assigned. Then, the command prompt changes to "Enter traffic
class for priority #>." Enter Traffic Class (0 to 3).
C
Move to the screen for configuring a scheduling method.
Press "C" to change the screen to Scheduling Method. Refer to the section 4.7.5.b for
how to set.
Q
Return to the previous menu.
120
Advertisement
Table of Contents
