Panasonic Switch-M8ePWR PN27089KA Operation Manual page 55

Screen Description
Port Displays the port number.
Trunk Displays the group number for a trunked port.
Type Displays the port type.
100TX
1000T
1000X
Link Displays the current link status.
Up
Down
Port Name Displays the port name.
EAP Pkt FW Displays the EAP packet forwarding function settings. For all ports, 'Disabled' is
the factory default setting. Set this item to "Enabled" to send EAP frames used in
IEEE802.1X authentication and "Disabled" to discard them.
Enabled
Disabled
Available commands are listed below.
A A name can be assigned to each port.
Press "A." The command prompt changes to "Select port number to be changed>."
Enter a port number to change the setting. To configure all ports at once, enter "0" as
the port number. Then, the command prompt changes to "Enter port name string>."
Enter a name in 15 characters or less. As the change is applied, the display on the
upper screen is updated automatically.
E Enable/disable the EAP packet forwarding function.
Press "E." The command prompt changes to "Enter port number>." Enter a port number
to change the setting. To configure all ports at once, enter "0" as the port number.
Then, the command prompt changes to "Enable or Disable EAP forward for port #
(E/D)>." Press "E" to enable the function. Press "D" to disable it. As the change is
applied, the display on the upper screen is updated automatically.
Q Return to the previous menu.
Note: The screen displays the port status; however, the status is not
automatically updated. To display the latest status, press any key.
The port type is 10/100BASE-TX.
The port type is 10/100/1000BASE-T.
The port type is SFP extension port.
A link has been established successfully.
A link has not been established.
The EAP Packet Forwarding function is enabled.
The EAP Packet Forwarding function is disabled.
55