Panasonic Switch-M8ePWR PN27089KA Operation Manual page 63

Available commands are listed below.
E Set Enable/Disable of access limitation via Telnet.
E Set access limitation from Telnet to Enable.
D Set access limitation from Telnet to Disable.
A Set an IP address to be permitted. Five ranges can be set up.
Press "A." The command prompt changes to "Enter IP address entry number>." Enter an
IP address entry number between 1 and 5. The command prompt changes to "Enter IP
address>." Enter an IP address to be permitted. If IP address is correct, the command
prompt changes to "Enter subnetwork mask>." Enter a range of IP address to permit
accessing with subnet mask format.
(Setting example)
No. IP Address
------ -----------------------
1 192.168.1.10
2 192.168.1.20
3 192.168.2.1
4 192.168.3.1
D Delete a range of IP address that has been set up.
Press "D." The command prompt changes to "Enter IP address entry number>." Enter an
IP address entry number to delete.
M Change a range of IP address that has been set up.
Press "M." The command prompt changes to "Enter IP address entry number>." Enter
an IP address entry number between 1 and 5. The command prompt changes to "Enter
IP address>." Enter an IP address that has been set up. The command prompt changes
to "Enter subnetwork mask>." Enter a range of IP address to permit accessing with
mask.
Q Return to the previous menu.
Subnet Mask Access permitted IP Address
------------------------------ ----------------------------------------------------
255.255.255.255 192.168.1.10
(Only one unit can be accessed)
255.255.255.254 192.168.1.20, 192.168.1.21
(Two units can be accessed)
255.255.255.128 192.168.2.1 to 192.168.2.127
(127 units can be accessed)
255.255.255.0 192.168.3.1 to 192.168.3.254
(254 units can be accessed)
63