Table of Contents
Advertisement
SNTP first update to
yyyy/mm/dd
FAN status changed
from good to failed
Temperature over
threshold.
Temperature under
threshold.
(Bridge) Topology
Change
PortX auto recovery.
The loop detected
between portA and
portB.
The loop detected on
portX.
(RRP) FDB Flush
(RRP) Ring Recover
(RRP) Ring Failure
(RRP) Change to
Link-Up Status
(RRP) Change to
Link-Down Status
(RRP) Change to
Pre-Forwarding Status
(TRAP)Usage power is
above the threshold
(TRAP)Usage power is
below the threshold
(TRAP)System
authentication failure
(TRAP)System Cold
Start
Available commands are listed below.
N
Show the next page.
Press "N." The screen displays the next page.
P
Show the previous page.
Press "P." The screen displays the previous page.
C
Clear all logs.
Press "C" to clear all logs.
Q
Return to the previous menu.
Indicates that the time was retrieved via SNTP for
the first time.
Indicates that a fan problem occurred.
Indicates that the internal temperature exceeded the
threshold.
Indicates that the internal temperature decreased
below the threshold.
Indicates that a topology change occurred in the
Spanning Tree function.
Indicates that Port X was automatically recovered
from being blocked after loop detection.
Indicates that a loop was detected between Port A
and Port B.
Indicates that a loop was detected in Port X.
Indicates that Forwarding Database was flushed.
Indicates that a ring topology was restored.
This log is displayed for the Master nodes only.
Indicates that a ring topology problem occurred.
This log is displayed for the Master nodes only.
Displays that a ring topology has been established.
This log is displayed for the Transit nodes only.
Indicates that a ring topology problem occurred.
This log is displayed for the Transit nodes only.
Displays that a ring topology is being established.
This log is displayed for the Transit nodes only.
Indicates that the PoE power supply exceeded the
threshold.
Indicates that the PoE power supply exceeded the
threshold and then decreased below the threshold.
Indicates that authentication from the SNMP
manager failed.
Indicates that this Switching Hub booted.
178
Advertisement
Table of Contents
