Table of Contents
Advertisement
4
.
C
o
n
f
i
g
u
r
4
.
C
o
n
f
i
g
u
r
Upon power ON, this Switching Hub starts working as a Switching Hub. To use the
SNMP functions and other functions, you need to configure the Switching Hub by
using the console, Telnet, or SSH.
In this chapter, the configuration of this Switching Hub is explained in detail.
Note:
To access this Switching Hub via Telnet or SSH, this Switching Hub must
have an IP address.
Therefore, before accessing this Switching Hub via Telnet or SSH,
configure an IP address by accessing this Switching Hub via console. For
details on configuring an IP address, refer to 4.6.2.
4
.
1
.
C
o
n
n
e
c
4
.
1
.
C
o
n
n
e
c
Console connection requires a DEC VT100-compatible asynchronous terminal, or a
terminal capable of running a VT100-compatible terminal emulator, such as
HyperTerminal on Windows XP or older. Connect a terminal of this kind to the
RJ45 console port of this Switching Hub.
Configure the communication mode for the asynchronous terminal as follows:
Transmission mode: RS-232C (ITU-TS V.24 compliant)
Emulation mode:
Transmission speed: 9600 bps
Data length:
Stop bit:
Parity control:
Flow control:
If you are using Windows XP or older, refer to "Appendix B. Procedures for
Console Port Configuration Using Windows HyperTerminal."
a
t
i
o
n
a
t
i
o
n
t
i
n
g
v
i
a
C
o
n
t
i
n
g
v
i
a
C
o
n
VT100
8 bits
1 bit
None
None
30
s
o
l
e
P
o
r
t
s
o
l
e
P
o
r
t
Advertisement
Table of Contents
