Table of Contents
Advertisement
4.6.7.d. SSH Server Configuration
On the System Security Configuration Menu, pressing "H" opens the SSH Server
Configuration screen, as shown in Fig. 4-6-15. On this screen, you can set SSH
server.
PN27089K/PN27089KA Local Management System
Basic Switch Configuration -> SSH Server Configuration
SSH UI Idle Timeout:
SSH Auth. Idle Timeout:
SSH Auth. Retries Time:
SSH Server:
SSH Server key:
-------------------------------- <COMMAND> -----------------------------------
[G]enerate SSH Server key
Set SSH UI Time [O]ut
Set SSH Authentication [R]etries Time [Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
SSH UI Idle
Displays the idle timeout settings (in minutes) for terminating a
Timeout:
SSH-connected session if no input is made.
The factory default setting is 5 minutes.
SSH Auth. Idle
Displays the time to wait for a response to SSH authentication.
Timeout:
The factory default setting is 120 seconds.
SSH Auth.
Displays the number of times of SSH authentication.
Retries Time:
The factory default setting is 5.
SSH Server:
Displays the SSH access settings.
'Disabled' is the factory default setting.
Enabled(SSH)
Disabled
SSH Server key:
Displays the SSH server key status.
Key exists.
Key does not exist.
60 Min.
120 Sec.
5
Disabled
Key exists.
Enable/Disable SS[H] Server
Set SSH [A]uthentication Time Out
Fig. 4-6-15 SSH Server Configuration
Access is enabled.
Access is disabled.
The server key exists.
The server key does not exist.
68
Advertisement
Table of Contents
