Transmission Failure Indication; Single Cable Rs-232; Single Cable Rs-232 Options - Datalogic Magellan 3300HSi Product Reference Manual

RS-232 Interface Features (continued)

Transmission Failure Indication

Enables/disables bad-label indication upon transmission failure.
START / END
Enable Transmission Error Indication
DEFAULT

Single Cable RS-232

Single Cable RS-232 Options

The RS-232 Single Cable interface shares some configuration options with
other RS-232 interfaces. Rather than repeat them in this section as Single Cable
options, please find them referenced as follows:
RS-232 Baud Rate on page
RS-232 Number of Data Bits on page
RS-232 Number of Stop Bits on page
RS-232 Parity on page
RS-232 Software Flow Control on page
RS-232 Beep on Not on File on page
RS-232 Label ID Control on page
62
PROGRAMMING bar codes
Disable Transmission Error Indication
-47
-48
-48
-48
-51
-56
-80
Magellan™ 3300HSI