Set Single Cable Rs-232 Etx Character - Datalogic Magellan 2200VS Reference Manual

Set Single Cable RS-232 ETX Character

162
Allows selection of the ETX character.
To specify the ETX Character:
1. Scan the SWITCH bar code.
2. Scan the bar code,
below. You'll need to cover any unused bar codes on this and
TER
the facing page to ensure the scanner reads only the bar code you
intend to scan.
3. Scan the appropriate characters/digits from the keypad in
that represent the decimal designation for the desired character. A
C
table containing the
decimal values is available in the inside back cover of this manual.
ASCII parameters must be input by scanning decimal digits for each
character. Pad all numbers with leading zeroes to yield a three-digit
entry (001-127). Thus, to set a single character value of A, bar codes
containing the digits '0', '6' and '5' must be scanned. The selectable
range for this option is any decimal value from 001 to 127.
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned.
SET SINGLE CABLE RS-232 ETX CHARACTER
SET SINGLE CABLE RS-232 ETX CHARAC-
ASCII Character Set
®
Magellan 2200VS/2200VS and 2300HS/2300HS
Appendix
and their corresponding