The projector feet are removable and can be moved to the top of the projector to run in an
inverted orientation.
2. Once the required adjustment is made, using a wrench, tighten the lock nut against the
bottom of the projector.
Turning on the projector
When the projector AC power supply is plugged in and the breaker switch is on, the power is on.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
1. Plug the projector into AC power and turn on the breaker switch.
When plugged in and the breaker switch is on, the projector automatically powers on to
standby mode within 60 seconds. The display panel functionality becomes available.
2. To turn on the light source using the projector keypad, select and hold the Power
until a beep sounds.
To turn on the light source using the remote, select and hold the ON button until you a beep
sounds.
Projector LED status indicators
Identify the LED state colors and meaning.
LED
State
Blue
Solid
Flashing
Green
Solid
Christie Griffyn Series Installation and Setup Guide
020-103314-12 Rev. 1 (07-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
Standby
Light source is off. Video electronics are off.
Projector status is OK.
Cool down
Projector is moving to one of the two standby
states:
• Light source is off and video electronics are
booting up.
• Light source is off. Video electronics and light
source is cooling down.
Light source on Light source is on. Projector status is OK.
Installation and setup
button
32