Table of Contents
Advertisement
Packaging tape is required to ensure safe shipment of the projection lens to restrain the zoom
ring from rotating during shipping.
Turning on the projector
When the projector AC power supply is plugged in and the breaker switch is on, the power is on.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
1. Plug the projector into AC power and turn on the breaker switch.
When plugged in and the breaker switch is on, the projector automatically powers on to
standby mode within 60 seconds. The display panel functionality becomes available.
2. To turn the light source on using the projector keypad, press and hold the Power
until you hear a beep.
To turn on the light source using the remote, press and hold the ON button until you hear a
beep.
Projector LED status indicators
Identify the LED state colors and meaning.
LED
State
Blue
Solid
Flashing
Green
Solid
Flashing
Yellow
Solid
Flashing yellow/green
Flashing
Flashing yellow/blue
Christie M RGB Series Installation and Setup Guide
020-103483-04 Rev. 1 (04-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
Description
Standby
Light source is off. Video electronics are off.
Projector status is OK.
Cool down
Projector is moving to one of the two standby
states:
• Light source is off and video electronics are
booting up.
• Light source is off. Video electronics and light
source is cooling down.
Light source on Light source is on. Projector status is OK.
Startup
Projector is moving to light source on state. Light
source is warming up. Video electronics are
initializing.
Warning in
Projector is in standby state. A problem exists with
standby
the projector that does not prevent it from
operating.
Warning during
Projector is in a startup state. A problem exists
startup
with the projector that does not prevent it from
operating.
Warning with
Light source is on. A problem exists with the
light source on
projector that will not cause it to shut down.
Warning during
Projector is in a cool down state. Light source is off.
cool down
Video electronics and light source are cooling
Installation and setup
button
29
Advertisement
Table of Contents
