Adjusting Parallel Running - Volkswagen Jetta 2005 Workshop Manual

The mark -arrow- on the rear of the guide upper section -1- must,
on both sides, lie within the marks dimension -a- on the guide
plate -2-.
• The guide plate -2- must be located in the guide rails (cannot
be moved by hand).
1.15

Adjusting parallel running

Note
The parallel running adjustment can only be made when the drive
and glass panel are removed ("0" position).
– Remove sliding/tilting sunroof glass panel drive
The mark -arrow- on the rear of the guide upper section -1- must,
on both sides, lie within the marks dimension -a- on the guide
plate -2-.
• The guide plate -2- must be located in the guide rails (cannot
be moved by hand).
– Push guide upper part -1- both sides centrally between the
marks.
– Install drive in this position (zero position)
– Then check zero position
⇒ page 171
⇒ page 171
⇒ page 172 .
Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
.
.
1. Sliding/tilting sunroof with glass panel (Meritor)
173