Volkswagen Jetta 2005 Workshop Manual page 319

4.3.1 Removing
– Remove rear door trim ⇒ General body repairs, interior; Rep.
Gr. 70 ; Door trim .
– Lower door window completely.
– Pull window channel -3- out of mounting.
– Remove screws -2- and pull trim -1- towards B-pillar
-direction of arrow-.
– Lever out cap -5-.
– Lift door window until spreader pin -3- and spreader plug -4-
in cut-out of window regulator is accessible.
Note
If the procedure cannot be carried out because there is a fault with
the electric window regulator, remove electric window motor to
slide window down.
– Screw a 5 mm bolt (approx. 70 mm long) into spreader pin
-3-.
– Pull bolt and spreader pin out of spreader plug -4-.
– Screw an 8 mm bolt (approx. 80 mm long) into spreader plug
-4-.
Note
Do not exert too great a pressure on the plug because otherwise
the plug will fall into the door.
– Pull spreader plug -4- out of clamping jaws -2- and therefore
out of door window.
– Pull window slot inner seal -6- off door inner panel.
Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
4. Rear door window (Variant)
309