Operating Without Current; Removing And Installing Guide Plate - Volkswagen Jetta 2005 Workshop Manual

1.18

Operating without current

Note
In the event of power failure, the sliding/tilting sunroof with glass
panel can be moved using a hexagon key directly on the drive.
Hexagon key is located in vehicle tool kit.
– Removing lights and front operating unit ⇒ Electrical system;
Rep. Gr. 96 ; Lights and switches in roof trim .
– Guide hexagon key into bolt on drive.
– Press key upwards -arrow- to release the drive.
The bolt will be pressed a few millimetres inwards -a-. Sliding/
tilting sunroof glass panel can only be moved in this position.
1.19

Removing and installing guide plate

1.19.1 Removing
– Removing glass panel for sunroof
– Using a screwdriver, unclip spacer -2- from guide plate -1- at
front and rear -arrows-.
– Pull spacer -2- in -direction of arrow- out of guide plate -1-.
– Lift guide plate up -1- in -direction of arrow-.
General body repairs, exterior - Edition 10.2009
⇒ page 166 .
Golf Variant 2007 ➤ , Jetta 2005 ➤
1. Sliding/tilting sunroof with glass panel (Meritor)
177