Volkswagen Jetta 2005 Workshop Manual page 221

2.20.2 Installing
– Remove existing adhesive residue using adhesive strip re‐
mover -VAS 6349- .
– Clean bonding surfaces on rear part and guide rails with clean‐
er -D 009 401 04- .
– Press a ∅ 3.5 mm butyl sealing cord -AKD 497 010 04 R10-
-2- as shown in illustration into adhesive canal on rear part
-1-.
– Push entire rear part -1- with discharge tubes -2- in direction
of -arrow- onto guide rail -3-.
– Tighten bolts -2- on guide rail -1- to 2 Nm.
Note
Before installation, it is recommended to check leak tightness of
assembly frame.
– Seal water drain hoses -1-.
– Fill marked area -3- between rear part -2- and guide rail -4-
with water.
– Wait for at least 5 minutes before checking leak tightness.
– Seal any leaks with butyl sealing cord -AKD 497 010 04 R10- .
– Install sun blind ⇒ page 199
– Install sun blind motor
– Install a new inner seal
– Install assembly frame
– On completion of work, establish reference points of all drives
for panorama sliding roof
.
⇒ page 198 .
⇒ page 193 .
⇒ page 208 .
⇒ page 183 .
Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
2. Panorama sliding sunroof (Arvin-Meritor)
211