Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
Observe rear door gap/shut lines ⇒ Body Repairs; Rep. Gr. 00 ;
Body dimensions .
To be able to adjust gaps correctly, bolts -6-, -7-, -11- and -12-
must be loosened.
Other measures such as raising the door have no effect. Subse‐
quent pressure from above will cause the door to sack again.
Bolts -4-, -5- and -13- and also guide bolts -2- and -8- must be
loosened to correctly adjust the flush fitting of the door.
Use door alignment tool -3320- with bit -3320/3- for this.
1.6.1
Adjusting striker pin
Note
The rear door must lock fully when closing without any addi‐
♦
tional force being required and must not have any play.
The rear door must not be pushed up or down as a result of
♦
the striker pin adjustment.
The following can be adjusted at the striker pin:
110
Rep. Gr.58 - Rear doors, door components