Volkswagen Jetta 2005 Workshop Manual page 196

Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
– Remove bolts -2- from glass panel -1- on left and right.
Note
To remove bolts, use a magnetic tool so that bolts do not fall into
mechanism of panorama sliding roof.
– Remove glass panel upwards.
Caution
To avoid damaging wind deflector, do not move tilting mecha‐
nism when glass panel is removed.
2.5.2 Installing
Note
Always use new bolts when installing or removing glass panel.
♦
♦ To screw in bolts, use a magnetic tool so that bolts do not fall
into mechanism of panorama sliding roof.
– Set glass panel -1- from top and screw bolts -2- without tight‐
ening them.
– Adjust front glass panel
– Tighten bolts -2- (5 Nm).
– Fit front trim panel -2- into glass panel -1- and slide in direction
of -arrow A-.
– Push trim panel in direction of -arrow B- onto bolt -4- and clip
locking lugs -4- on back.
– On completion of work, establish reference points of sliding
sunroof motor ⇒ page 183
186
Rep. Gr.60 - Sunroof
⇒ page 188 .
.