Volkswagen Jetta 2005 Workshop Manual page 75

The retaining rails are bolted to the inner part of the door and
bonded to the outer panel of the door.
The inner part -6- of the door functions basically as the previously
known assembly carrier. Loudspeaker, window regulator, window
regulator motor, wiring, window channel, exterior mirror and door
lock are mounted on the door inner part.
The outer panel -1- of the door is additionally bolted to the lower
edge of the inner part. The window slot outer seal, insulation and
exterior door handle are mounted on the outer panel of the door.
Caution
Different securing screws are used for the door outer panel. If
these are fitted in the wrong positions, the outer panel for the
door will be damaged.
Note
The edge protection foil -2- must always be bonded between the door outer panel and the door inner part.
1 - Door outer panel
❑ Removing and installing
⇒ page 112
2 - Edge protection foil
❑ Self-adhesive
❑ Is bonded between door
outer panel and door in‐
ner part.
3 - Bolt
❑ Feature: bolt with poin‐
ted end and thinner
washer.
❑ Qty. 6 on lower edge
❑ Qty. 1 in rear section of
door shoulder
❑ 10 Nm
4 - Rear retaining rail
❑ Adhesive -DH 009 100
03-
5 - Bolt
❑ Feature: bolt with no
pointed end and thicker
washer.
❑ Qty. 10 for both retain‐
ing rails
❑ 14 Nm
6 - Door inner part
❑ Assembly overview
⇒ page 84
7 - Front retaining rail
❑ Adhesive -DH 009 100
03-
Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
65
1. Front door