– Remove side seal -2- from profile of rear glass panel -1-.
– Remove existing adhesive residue using adhesive strip re‐
mover -VAS 6349- .
– Bonding surface on glass panel must be free of dust and
grease.
– Clean bonding surface completely using cleaning solution -D
009 401 04- .
Note
New seal is supplied in excess length. Cut new seal to appro‐
♦
priate length. It is recommended to leave new seal 1-2 mm
longer and to sprain any excess length.
To guarantee a good bonding of seal, do not bond at a tem‐
♦
perature below 20°C.
– Pull off protective backing from adhesive tape of new seal.
– Set new seal -2- with fastener -3- on glass panel -1-.
– Press seal on both ends.
– Press seal -2- onto profile of glass panel -1- and sprain any
excess length evenly.
– Press in seal evenly using roller for door insulation foil -3356- .
– Install rear glass panel
2.9
Renewing outer seal
– Remove front glass panel
– Remove rear glass panel
⇒ page 187
.
⇒ page 185
.
⇒ page 187
.
Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
2. Panorama sliding sunroof (Arvin-Meritor)
191